Most convectors, recessed into the floor, supplied with copper-aluminum heat exchanger, ie a copper tube threaded into one or more calls a package of rectangular aluminum plates. For the life of the instrument is important, as these thin plates are attached to the tube. If they are stamped Flare increases the contact area a few [...]
Posts under ‘Radiant Heating’
Intellectualize equipment
In the process of modernizing the manufacturer seeks to primarily take into account the interests of the buyer. After all, many of them recently it seems important to operate the heating and water heating equipment in the individual, suitable concrete shelter mode. Make the device more sensitive to the desires of the consumer allows the [...]
Fans
Most embedded in the floor convectors can detect so-called tangential fan (in the number of 1-4, depending on the length of the instrument). The design – a electric motor, to which one or both sides were attached long “pin” – the impeller. The device is installed parallel to the heat exchanger. Tangential fans create a [...]
Convectors with fans
Thermal power embedded convectors with fans, reduced to one meter in length, is within approximately 100 watts when the fan is turned off (the device warms the room by natural convection) up to 1200 watts or more if the fans operate at maximum speed. (Sam fan consumes per hour only a few tens of watts [...]
Not a single grating
Of course, if the coil included a decorative grille, they would be applied universally, and the whole procedure for choosing the device would be reduced to a purely design problems. However, in practice much harder. The choice of the lattice is carried out at the last turn, after clarification of all the thermodynamical characteristics and [...]
General recommendations for installation of PEX plumbing tubing
The bottom of the trenches tamped and smoothed with a mixture of dry limestone gravel with coarse sand. Then laid PEX plumbing tubing. The minimum slope plumbing on the building regulations is 0,002 (2 mm to 1 running. M) in clay soils, and 0,003 (3 mm at 1 running. M) in the sand. In practice, [...]
Steel radiators KERMI
Company KERMI (Germany) for 40 years takes the leading position in Europe for the production of heating appliances. The most popular steel radiators, which accounted for 95% of all sold in Europe heaters. Steel panel radiators have special properties not possessed by other types: * They are designed to work in modern energy-saving automated closed [...]
Takagi water heaters for gas savings
In addition to the control device Takagi is possible to increase or decrease the temperature of the coolant, without changing the heating curve, and shifting it from the slope in the direction of greater or lesser temperature. All control devices have the additional regulation, which allows to quickly adjust the temperature of the coolant in [...]