Most convectors, recessed into the floor, supplied with copper-aluminum heat exchanger, ie a copper tube threaded into one or more calls a package of rectangular aluminum plates. For the life of the instrument is important, as these thin plates are attached to the tube. If they are stamped Flare increases the contact area a few [...]
Posts Tagged ‘radiant heating’
Intellectualize equipment
In the process of modernizing the manufacturer seeks to primarily take into account the interests of the buyer. After all, many of them recently it seems important to operate the heating and water heating equipment in the individual, suitable concrete shelter mode. Make the device more sensitive to the desires of the consumer allows the [...]
Fans
Most embedded in the floor convectors can detect so-called tangential fan (in the number of 1-4, depending on the length of the instrument). The design – a electric motor, to which one or both sides were attached long “pin” – the impeller. The device is installed parallel to the heat exchanger. Tangential fans create a [...]
Convectors with fans
Thermal power embedded convectors with fans, reduced to one meter in length, is within approximately 100 watts when the fan is turned off (the device warms the room by natural convection) up to 1200 watts or more if the fans operate at maximum speed. (Sam fan consumes per hour only a few tens of watts [...]
Convectors without fan
In central Canada radiant heaters without fans are usually used as an additional heating of premises, together with a system of floor heating. In such a bond they noticeably (several times) accelerate the reaction equipment to the rapid decrease or increase in temperature in the house. And in the spring and fall warm floor can [...]
Not a single grating
Of course, if the coil included a decorative grille, they would be applied universally, and the whole procedure for choosing the device would be reduced to a purely design problems. However, in practice much harder. The choice of the lattice is carried out at the last turn, after clarification of all the thermodynamical characteristics and [...]
Convectors recessed in the floor
Windows from floor to ceiling – a dream of many developers. But here’s how to heat the room, decorated with these transparent structures? Traditional batteries under high windows can not put – will block the light of day, to spoil the view of the neighborhood to come into discord with its surroundings and to distort [...]
Basic principles of management of modern water heater plants
Modern heating system consists of several units, which provide space heating through radiators to maintain comfortable conditions in the bathrooms with underfloor PEX heating, coolant supply with the required temperature for hot-air heating and water heating in swimming pools. As part of any autonomous heating system, there is usually a water heater plant, which is [...]